×
公司网站
×

FY6800

Browse:
Taobao link: See details
Add Time: 2018-04-10 10:38:08
Recommendation:

Introduction

Printed text       Big   in    Small

       

FY6600 series dual-channel function/arbitrary waveform generator is a set of function signal generator, arbitrary waveform generator, pulse signal generator, frequency sweeper, counter and frequency meter in one function, high performance, cost-effective, multi-function Signal generator. Rich shortcut keys greatly simplify the complex operation process and greatly enhance the operability of the instrument. Users do not have to spend a lot of time to learn and become familiar with the operation of the instrument, and they can use it proficiently. Particularly suitable for electronic enthusiasts, scientific research institutions and high-tech enterprises.


         The instrument adopts DDS direct digital synthesis technology to produce accurate, stable, low-distortion output signals. All parameters are calibrated by internal programs; standard PC software, all functions of the instrument can be controlled by the host computer software, and also can use the upper position. The machine software saves the arbitrary waveform and saves the output waveform to the signal generator; the communication protocol is open, making the secondary development very simple; large-scale integrated circuit, surface mount technology, high reliability, long service life; and output short-circuit protection Yes, all signal outputs can work 60s under load short-circuit conditions.


1. The FY6600 uses a professional 14Bit high-speed D/A chip instead of a 12-bit D/A resistor network built with several inexpensive resistors. The higher the resolution, the smoother the waveform details. It is recommended to use an oscilloscope to reduce the amplitude resolution and time base to observe the details of the sine wave. The waveform detail and smoothness of the two solutions will immediately jump on the paper.


2. The FY6600 series sampling rate is upgraded to 250MSa/s, and the waveform contour of the instrument is much clearer than the 200MSa/s sampling rate at the same frequency;

3, FY6600 series waveform memory depth upgrade to 8192 * 14bits, high-precision signal details can be restored. The waveform length is 4 times that of your partner.

4, the industry's original very practical VCO function, see the feature introduction.

5, FY6600 series phase resolution up to 0.1 degrees, users can more accurately control the delay of the two signals;

6, the signal output terminal using pure copper material, not plastic coated zinc alloy material, the details are attitude;

7, the instrument uses imported long-life keys, feel comfortable;

8. The first two-channel waveforms are displayed on the LCD interface at the same time. (The non-allegative users mimic our 2015 version and only indicate one waveform)

9, 4 TTL output makes the application of the instrument more extensive;

10, small signal is particularly good, FY6600 can output 1mVPP small signal amplitude resolution of 1mV, and can be done 1mVpp, 10mVpp, 100mVpp, 1Vpp and other different step values, the maximum amplitude range 1mVpp~20Vpp stepless adjustment .

11, the frequency range is wider, the maximum frequency range of sine wave is 1uHz~60MHz, the maximum range of square wave is 1uHz~25MHz, other wave frequency range is 1uHz~20MHz, the full range of frequency resolution is 1uHz, the whole range of frequency is not divided, direct digital setting ;

12. The rising edge time within the square wave 5V is as low as 7nS, and the maximum output frequency can reach 25MHz;

13, more abundant waveform types, the instrument not only presets 33 kinds of common waveforms for the user, but also provides users with up to 64 groups (8192 * 14Bit) of user-defined waveform storage space, the user can use the host computer provided by our company Software editor download; it is worth mentioning that our pulse wave pulse width not only supports the duty cycle adjustment method, but also supports the pulse width to be accurately set between 20nS-1S (our friend's products mimicking our interface do not have this adjustment Way). The instrument output waveform totals 97 groups.

14, powerful scanning function, the instrument not only supports the internal parameter settings on the signal frequency, amplitude, duty cycle, bias level parameters of the scan, but also supports the external analog voltage on the instrument output frequency, amplitude, duty cycle, bias Level modulation;

15, more comprehensive measurement function, the instrument can measure the signal frequency, period, positive pulse width, negative pulse width and duty cycle, and all parameters are displayed in the same interface, do not need to flip back and forth view; counter function has DC And AC two kinds of coupling methods, effectively solve the problem of AC coupling count inaccurate. The maximum measurement frequency of the instrument can reach 100MHz, and the minimum measurement frequency is 0.01Hz.

There are still some advantages that we will not list. We would like to share with you.

 

Frequency

Model

FY6800-20M   

FY6800-30M

FY6800-50M

FY6800-60M

Sine

0~20MHz

0~30MHz

0~50MHz

0~60MHz

Square

0~15MHz

0~25MHz

0~25MHz

0~25MHz

Ramp, Triangle

0~10MHz

0~10MHz

0~10MHz

0~10MHz

Pulse

0~10MHz

0~10MHz

0~10MHz

0~10MHz

TTL/CMOS

0~10MHz

0~20MHz

0~20MHz

0~20MHz

Arbitrary Waveform

0~10MHz

0~10MHz

0~10MHz

0~10MHz

Minimum pulse width

20ns(All models of pulse wave minimum width can   reach 20ns)

Min. Resolution   on all frequency range

1μHz (Min.   resolution can reach 1μHz on all frequency range to ensure adjusting accuracy   under high frequency. For example, it can output 10.000000000001MHz signal).

Accuracy

±20ppm

Stability

±1ppm/ 3hours

Waveform   Characteristics

Waveforms

Sine, Square (Duty Cycle adjustable), Pulse (Pulse width and cycle time   can be set accurately), Triangle/Ramp, Sawtooth   Wave, CMOS, Four channels TTL, DC, Half wave, Full wave, Positive Step,   Inverse Step, Positive Exponent, Inverse Exponent, Lorenz Pulse, Multitone,   Noise, ECG, Trapezoidal Pulse, Sinc Pulse, Narrow Pulse, Gauss White Noise,   AM, FM, and other 64 sets customer-defined waveform.

Non-Volatile   Storage

Can store 64   user-defined arbitrary waveforms, (8K 14bits) * 64

Waveform Length

8192 points * 14bits

Sampling Rate

250MSa/s

Vertical Resolution

14 bits

Sine

Harmonic   Suppression

≥50dBc(<1MHz);   ≥45dBc(1MHz~20MHz);

Total Harmonic Distortion

<0.5%   (20Hz~20kHz,0dBm)

Square

Rise/Fall Time

≤7ns (VPP<5V)

Overshoot

≤5%

Duty Cycle

0.01%~99.99%   (Resolution 0.01%)

Sawtooth wave

Linearity

>99%   (0.01Hz~10kHz)

Output   characteristics

AmplitudeVPP

Frequency≤10MHz:   1mVpp~20Vpp;

10MHz<Frequency≤20MHz:   1mVpp~10Vpp;

Frequency>20MHz:   1mVpp~5Vpp;

Resolution

1mV

Amplitude Stability

±0.5%/   5 Hours

Amplitude flatness

±2.5%(<10MHz);±5%(>10MHz);

Waveform Output

Impedance

50Ω±10%Typical

Protection

All channels can work more than 60 seconds   when the load is short-circuited.

DC Offset

Offset    Range

Frequency≤20MHz:   ±10V;  Frequency>20MHz: ±2.5V;

Offset Resolution

1mV

Phase Feature


Phase   range

0~359.99°

Phase resolution

0.01°

TTL Output


TTL Level   Amplitude

>3Vpp

Fan-out

>8 TTL LOAD

Rise/Fall Time

≤10ns

CMOS Output

Low Electric Level

<0.3V

High Electric Level

1V~10V

Rise/Fall Time

≤18ns

External Measurement

Function

Frequency, Period, Positive/Negative Pulse Width, Duty Cycle

Input   Voltage Range

1Vpp~20Vpp

Frequency   Meter

Resolution

0.01Hz (Gate Time = 100S)

Range

0.01Hz~100MHz

Sensitivity

Gate Time 3   grades (1S, 10S, 100S) adjustable

Counter

Range

0-4294967295

Coupling

DC, AC

Working Mode

Manual

Period

Measurement   Range

5ns ~ 20s

DC coupling   measurement

Pulse Width

Measurement   Range

0ns ~ 20s

Resolution

5ns

Duty Cycle

Range (Display)

0% ~ 100%

Sweep

Carrier   Waveform

Sine,   Square, Ramp, Arbitrary (except DC)

Sweep Type

Linear or   Logarithm

Sweep Direction

Up, Down and roundtrip sweep directions;

Sweep   Objects

Frequency,   Amplitude, Offset, Duty Cycle

Sweep Time

0.01S~999.99S/Step

Setting range

Starting   position and Finishing position can be set arbitrarily.

Sweep Range

Decided by Parameters setting.

VCO   (Voltage   Control Output)

Modulation signal range to input

0~5V

VCO signal frequency range

0-1000Hz

VCO control object

voltage controlling frequency (VCF), voltage controlling amplitude   (VCA), voltage controlling offset, voltage controlling duty cycle.

VCO special function

Can Amplitude Modulate (AM) or Frequency Modulate (FM) by external analog   signal.

Modulation

Modulation Type

AM, FM, PM, ASK, FSK, PSK

Carrier Waveform

Sine, Square, Triangle, Ramp, Arbitrary waveform (Except DC)

AM

Source

Internal (CH2) / External (VCO IN Port)

Modulating Waveform

Sine, Square, Triangle, Ramp, Arbitrary waveform

Depth

0% to 100%

Modulating Frequency

Internal : 1μHz~1MHz;  External:   1μHz~2KHz;

FM

Source

Internal (CH2) / External (VCO IN Port)

Modulating Waveform

Sine, Square, Triangle, Ramp, Arbitrary waveform

Modulating Frequency

Internal : 1μHz~1MHz;  External:   1μHz~2KHz;

PM

Source

Internal (CH2) / External (VCO IN Port)

Modulating Waveform

Sine, Square, Triangle, Ramp, Arbitrary waveform

Phase Deviation

0° to 360°

Modulating Frequency

Internal : 1μHz~1MHz;  External:   1μHz~2KHz;

ASK

Source

Internal (CH2), External (ASK IN Port), Manual

Modulating Waveform

Square with 50% duty cycle.

Key Frequency

1μHz~10MHz

FSK

Source

Internal (CH2), External (FSK IN Port), Manual

Modulating Waveform

Square with 50% duty cycle.

Key Frequency

1μHz~10MHz

PSK

Source

Internal (CH2), External (PSK IN Port), Manual

Modulating Waveform

Square with 50% duty cycle.

Key Frequency

1μHz~10MHz

Burst   Function

Carrier   Waveform

Sine,   Square, Ramp, Arbitrary (except DC)

Burst Count

1~1048575

Trigger Source

Manual, Internal, External (AC/DC)

General   Specifications

Display

Type

2.4 inch, TFT Color Display.

Save & Load

Amount

20

Position

01 to 20 (01 for start default value)

Interface

Type

USB to Serial interface

Protocol

Command line mode, providing communication   protocols.

Communicating Speed

115200bps (Industrial standard)

Power

Voltage Range

AC100V~240V

Technic

SMD, LSI, Reliable and durable

Buzzer

Can be turned on/off by setting.

Operation

Buttons and knob   continuously.

Environment

Temp.: 0~40, Humidity: 80%

Size

200mm * 190mm *   90mm (L * W * H)

Weight

900g

Package   Size

25cm * 21cm *   10cm (L * W * H)

Package Weight

1kg(Main engine,   accessories and packing materials)



Annex:

On AFY6600
NextFY6900

 Products

products

feeltech professional production of LCD modules and signal generator, providing industrial color LCD…

See more

Contact

Tel
0371-63223286
Online Customer Service
Sales customer technology customer
Address
High-tech Enterprise Accelerator in Zhongyuan District, Zhengzhou City, Henan Province, China
Pay Attention ToOfficialWeChat


Hello Sayhell,Welcome You To Give Us A Question

Full NameName
TitleTitle
EmailEmali
Contact PhoneTel
ContentContent
ScanningVisitMobile Version
Copyright © feeltech
  Powered by FeelTech
豫ICP备16016058号-1
-->